With 10 hours Sun; 105kWh/p 10hr Day fitted with 15x 700W panels. 82kWh/p 10hr Day fitted with 15x 550W panels. 66kWh/p 10hr Day fitted with 15x 445W panels.
Ideal for Commercial & Industrial energy consumption.
This sized DART module supplies enough energy for a large Residential or Semi-Commerecial energy consumption.
DART-15 with 700W Solar Panels.
DART-15-700 with 220cm Ground Clearance for Livestock.
DART-15 with 380W Solar Panels Accessible from the back of a Ute.
DART-15 with 200cm Main Mast.
380W BlueSun Solar Panels.
Under the Racking.
Lowering Assembled Racking onto the Mast.
Two DART-15 units.
24V DC Anemometer (Wind Sensor).
Oversized Trenching.
Foundation Cages Made in Australia.
Letting Cement harden before Installation.
Setting up the Main Mast Level.
The Main Mast levied.
19
DART-15 Spacing Brisbane Latitude.
DART-15 Spacing Sydney Latitude.
DART-15 Spacing Melbourne Latitude.
All Double Flanged Foundation Pole Holes, should have an additional 30cm depth, to provide a 30cm Cement Bed below the bottom Flange Plate !
Cemented block with Piles, Anchor Bars & Booka-rods set 20cm above Ground.
Piles with Booker-rods Welded to Anchor Plates.
Finished Foundation with only the Booka-rods above Cement.
The Angles or Rotation of all DART Racking.
For those looking to Dig or Auger there own Foundation holes;
A Caged re-bar Foundation requires a 90cm Diameter Foundation Hole.
NB: It is important to allow an additional 30cm Hole depth, this provides a 30cm Cement Bed below the bottom Flange Plate to take the vertical load of the DART.
We advisable to install a Earth/Ground spike at the same time, old school would be a Re-bar or Star Picket.
The Below information is required before we manufacture a DART unit to your Specification;
1. Required Panel Clearance from the ground, when Racking is at 60 degree tilt ?
2. Tell us how many kWh of Energy you want to Generate per Day ?